How to Make Your Own Chili Powder

How to Make Your Own Chili Powder

It’s not hard to do. You don’t need any special equipment. It’s fun. And you end up with an incredibly good, fresh, unadulterated chili powder that will (excuse me, McCormick) put all those little bottles to shame. Not only that but, once you learn how to turn dried chiles into chili powder, you can keep a stock of your favorite chiles on hand to use whenever you wish, even if you live in an area where chiles are not readily available.
Now, the following recipe is a guide – something you can go by. The whole point of making your own chili powder is to make it to your own personal taste.

Assemble the following ingredients:

For mildness and flavor:
4 Ancho chiles (dried poblanos)
3 Dried New Mexico chiles
For heat:
3 to 5 Dried Chiles de Arbol or Cayenne
For flavor:
2 T Cumin seeds, toasted 2 T Garlic powder 2 t Ground oregano (Mexican oregano, if you can get it)

Preheat your oven to 300°F.
Remove stems and seeds from all the chiles. Cut each chile in half with scissors and flatten the pieces. Incidentally, good dried chiles will still have some moisture in them and be fairly pliable. Don’t use dried chiles that are so dry and fragile that they shatter when touched. Chile ristras and wreaths are wonderful decorative accents, but the chiles dry out and lose their flavor.
Put the chiles in a single layer on a baking sheet and bake for 4 or 5 minutes. Remove the pan and check the chiles (they cool almost immediately). The smaller chiles will be toasted first, so remove them and set aside. Bake the larger pieces another 4 minutes and check again. The poblanos will be done last, but as portions of them toast, break them off and set aside returning the pan to the oven if necessary.
When all chiles are toasted and crispy, break each piece into two or three pieces and place in a blender. Pulse briefly until you have powder.
Toast the cumin seeds by placing them in a dry skillet over medium heat. Stir the seeds constantly being very careful not to let them scorch. When they are a few shades darker than the untoasted seeds, they are ready. Grind the toasted seeds with a mortar and pestle or with a rolling pin between two sheets of waxed paper.
Add the ground cumin, garlic powder and oregano to the ground chiles in the blender. Pulse a few more times to thoroughly mix the powder, and you’re through. You should have about 1 cup of chili powder, depending upon the size of your chiles.
The chiles and other ingredients can be varied according to your taste. To add the smoky heat of chipoltes (smoked jalapeños), for instance, substitute a chipolte for one of the chiles de arbol. Or better yet, toast some chipoltes and make a pure chipolte powder from them. A teaspoon of chipolte powder is the rough equivalent of one chipolte chile.
Store your chili powder in a small, airtight container like a glass jar with a lid that can be tightened. If you make more chili powder than you will be using in the immediate future, triple bag it in plastic bags and put it in the freezer.